|
Benefits :
1. Linear separable LED strip on flexible
printed circuit board with self-adhesive
back
2. Each unit of 3 LEDs can be cut out at
regular segments without damaging the rest
ribbon
3. The connector is being upgraded . we will
keep customers to be informed.
APPLICATIONS
1. Edge-lighting of transparent or diffused
materials
2. Path & contour marking
3. Illuminated signs
Basic technical data:
1. Colour: single color RGB tri-color RGB
tri-color-B
2. Ribbon width: 8mm, -A 10mm, 12mm
3. Printed circuit board thickness: 0.25mm
0.2mm 0.2mm
4. Working voltage: 12V DC 12V DC 12V DC
5. Working current: 2A 3A 4.8A
6. Entire ribbon LED quantity: 300 pcs
150pcs 240pcs
7. Size of smallest unit 3 LED: (L*W)
50mm*8mm 100mm*10mm 100mm*12mm
8. Standard length: 5 meters/reel 5
meters/reel 8 meters/reel
Assembly information:
1. Solder connection should only be
performed on designated solder pads
(marked’+’).During soldering ,don’t exceed
the maximum soldering time of 10 seconds and
the maximum soldering temperature of 260
Celsius degrees.
2. The smallest unit (50mm or 100mm –3LEDs)
can be removed by cutting with scissors
between the esignated solder pads.
3. The mounting of the ribbon is facilitated
by means of the double-sided adhesive on the
back-surface of the ribbon. Care must be
taken to provide a clean and dry mounting
surface, free of oils or silicone coatings
as well as dirt partied . the mounting
substrate must have sufficient structural
integrity. Take care to completely remove
the adhesive backing. One the ribbon is
appropriately positioned. Press on the
ribbon with about 20N /cm2(refer to
application techniques of 3M adhesive
transfer tapes)
4. The minimum bending radius is 2 cm . the
ribbon may be bent over a smaller radius of
the circuit board containing no electronic
components and such bends should be made
once and fixed in position to avoid cyclic
fatigue .
Safety information:
1. The SMD light ribbon itself and all its
components may not be mechanically stressed.
2. Assembly must not damage or destroy
conducting paths on the circuit board.
3. Installation of LED modules (with power
supplies)needs to be made with regard to all
applicable electrical and safety standards.
Only qualified personnel should be allowed
to perform installations.
4. Correct electrical polarity needs to be
observed. Wrong polarity may destroy the
ribbon .
5. Parallel connection is highly recommended
as safe electrical operation mode. Serial
connection is not recommended . Unbalanced
voltage drop can cause hazardous overload
and damage the ribbon.
6. Please ensure that the power supply is of
adapters power to operate the total load.
Electrical isolation points between ribbon
and the mounting surface.
7. Pay attention to standard ESD precautions
when installing the ribbon.
8. Damaged by corrosion will not be honored
as a materials defect claim. It is the
user’s responsibility to provide suitable
protection against corrosive agents such as
moisture and condensation and other harmful
elements.
|
